Mustang II 4-3/4 Bolt Pattern Disc Brake Kit


PARTS LIST:
1. 4216 CALIPER BRACKETS
2. BCA# LS8110 INNER RACES
3. NATIONAL SEAL #710058
4. 82-88 CHEVY CAMARO ROTORS AIMCO# 5547 - (NOTE. THE STUD / LUG NUT SIZE ON THIS ROTOR IS METRIC 12mmX1.5)
5. 2 SPINDLE NUTS CUT DOWN TO A WIDTH OF .225"
6. USE STOCK MUSTANG 11 INNER AND OUTER BEARINGS
7. CHEVY DUST CAP x 2
   
ASSEMBLY:
1. REMOVE INNER RACE SUPPLIED WITH ROTOR AND REPLACE WITH NEW L681 10 RACE. MAKE SURE TO DRIVE RACE IN STRAIGHT AND AS DEEP AS POSSIBLE.
2. GREASE INNER BEARING AND INSTALL ALONG WITH #710058 SEAL
3. INSTALL CALIPER BRACKET ON CLEAN  UNDAMAGED SPINDLE USING NEW BOLTS AND LOCKWASHERS.
4. INSTALL NEW ROTOR ON SPINDLE FOLLOWED BY A GREASED OUTER BEARING, KEYED WASHER, and SPECIAL WIDTH SPINDLE NUT. TIGHTEN TO MANUFACTURES SPECIFICATION THEN INSTALL RETAINER CAGE, COTTER PIN, AND DUST CAP.
5. INSTALL CALIPERS WITH BLEEDER SCREW POINTING UP. NEXT, INSTALL BRAKE HOSE.

 

|  Search |  Illustrated Installation Guides  |  E-mail Us |

   

800-979-4278